If cross cable is to be made, we must remember that the other end must be screwed in accordance with T568A standard. We repeat the same process for the other end. We visually check that the pins and the connector is fully seated. We tighten the crimping tool to ensure that the pins on the connector are jammed and the cable strand is bitten by them. We hold the RJ45 connector and cable carefully and place it in the RJ45 connector tightening area of the crimping tool. After insertion you have to ensure that cables are inserted with correct order. Please be careful, don’t lose the cable order when inserting cables. We steer the cables properly while you hold them, in while you need to slowly insert them into the RJ45 connector in the proper sequence. To determine the length as an estimate, we can make a measurement with connector and cut it accordingly. While keeping the cables together in the proper sequence, we cut the cable lengths so that they are about 1.2 cm long. In other words, the first side should prepare as above, the second end should be Orange-White at 3, Orange at 6, Green-White at 1 and Green at 2. If you are preparing cross cable, we need to order one side according to standard T568B and the other side according to T568A. Separate pairs from each other and order them according to color code. Cat5E cable does not have such a regulator. If you are using a Cat6 cable, we have a plastic cable organizer in the middle of the cables and we cut the nylon cable from the bottom. Saperate the Pairs and Remove the Protector in the Middle We make a cut from about 2,5 cm from both ends of the cable and peel off the PCV cable sheath that is located here.Ģ. Since we have prepared our tools, we are following the way to make cables 1. You can make test with your computer, if you have no test tool. The test tool is used to check whether all ends of the cable are functional and whether the cable is properly working or not. This tool is special for making Ethernet cable, no any other tool can be used this purpose. We will use it to shorten and straighten the cable end. Cutting Tool or Side Cutter (also scissor can be use) If you have not, you can use sharp knife, modelling knife or sharp part of the crimping tool cab be used for this purpose.Ĥ. In particular, the Cable Stripping device can be used. It is used to cut the plastic part to open from the end of the cable. It is important that our connector is of good quality and proper to Cat5E or Cat6 standard.

Create loopback cable rj45 step by step